How to weave a bracelet from the fabric
With the help of this article, you can in a few minutes make a very stylish and Original bracelet. All you need is two fabric strips of a certain length and your hands. This incredibly simple technique of weaving a little like a pigtail.
It's hard to believe that a thing so simple in execution can look so impressive. Especially since this season such bracelets are just At the height of fashion.
You will need 2 strips of knitted fabric 2-3 cm wide and 1.40 m long. It is important to choose the right material that will stretch.
At the ends of strips of fabric, make a small incision.
To get these holes.
Put strips of cloth against each other in such a way that the holes coincide.
Take the lower end of the strip and pass through this double hole.
So you can combine two strips without using nodes.
Place the strip between the thumb and forefinger. Leave about 10 cm on the palm of your hand, wind it over your ring finger and hold it in front of your little finger.
Wrap a strip around the little finger and ring finger.
And then slightly higher around both fingers at once.
Take the little ring on the little finger and wind it over your finger.
Repeat the same with the ring finger.
Repeat the last three steps again and again until you get a bracelet of the right length.
After some time the result will turn out this way.
When the bracelet is of the necessary length, put both eyelets on one finger.
And spend the remainder of the tissue strip through these loops.
Tie the ends of the bracelet to two nodules.
And now our bracelet is ready. If you understand how this is done, you can cope with this task in less than 5 minutes.
You can once again carefully see how this bracelet is made on this video:
If you want to make a bracelet wider, you can use the middle and index fingers when weaving. Choose the color of the fabric that best fits your wardrobe, and you'll get Cool accessory In your collection.